Good Day folks,
I hope you could assist. Not sure what i am doing wrong or where i might have gone wrong.
Basic Configuration of SOLMAN_SETUP STEP3.1 : CA Wily Introscope
Image may be NSFW.
Clik here to view.
1. I am getting an error message EM is Offline (above image).
2. Also not sure if i need to Install Wily Introscope on my Satellite Systems (DEV, QAS and PROD) (Documentation was not very clear on this)
3. If i have to, Can i use the Remote Installation on the CA Wily Enterprise Managers Administration to deploy on remote systems. i believe i will need to install EM Stand-Alone.
4. Lastly and i believe the answer to this question will depend on the answer provided in question 3. just need to make sure i cross all my I's and dot all my T's. When adding the satellite system on EM where it asks for Installation path do i provide the local solman installation path or that of the satellite system?
Image may be NSFW.
Clik here to view.
on the Remote Administration Tab the Start button is grayed-out.
Image may be NSFW.
Clik here to view.
Any assistance you could provide will be very grateful.
Thank you in advance
Regards,
Johann
